Mr. Heater HST45 Instrucciones de operaciones descargar pdf (Pagina 4)

Enerco Group, Inc.,| Gas-Fired Low-Intensity Infrared Heater Operating Instructions and Owner’s Manual

- Rear View -

Rear Movable Hanger

at Exchanger

Reflector

Front Fixed Hanger

About The Heater

Burner Box

ntrol Side

Access

Burner Box Contains the electrical components (i.e. blower motor, power transformer, etc.) and gas distribution components

(i.e.

gas valve, etc.) that make the heater work. There are no owner serviceable items contained in this box.

Front Fixed Hanger Provides rigid support and mounting surface for the reflector. Holes are provided in the upper corners of the

bulkhead

to accommodate suspension hardware required for installation of the heater.

Reflector The reflector is made from formed aluminum and reflects the radiant energy downward to the space to be

ated.

Heat Exchanger A U-shaped tube through which the heated products of combustion pass.

Rear Movable Hanger Provides support for the heat exchanger and reflector at the end that is furthest from the burner box. The

suppo

rt may be moved (within limits) to accommodate hanging of the unit.

Service Door To be removed only by a licensed contractor. Removal of this service door provides access to the electrical and

gas

distribution components.

Intake Vent Accomondates a 3" diameter combustion air inlet duct that delivers fresh air to the burner.

Exh

aust Vent Accomondates the air-venting duct that carries the products of combustion to be vented outdoors.

Nipple

– ½ NPT Point at which the gas supply is connected to the heater.

Power Cord Includes a three prong plug that must be connected to a dedicated and properly grounded three prong ceiling

outl

et.

Exhaust Vent

Intake Vent

1/2" NPT

Power Cord

1 2 3 4 5 6 7 8 9 ... 23 24

Sin comentarios

Mr. Heater HST45 Instrucciones de operaciones Pagina 4